I used mini perler beads for this ornament. The mini beads are super small. You need tweezers to pick them up and to arrange the pattern. You will also need a pegboard, an iron, and the iron paper.
Here is the pattern. If you’ve used perler beads before, make sure your iron is hot enough. I had mine too low and when I picked up the iron, the beads went flying everywhere.
Thanks for stopping by!
Here is the pattern. If you’ve used perler beads before, make sure your iron is hot enough. I had mine too low and when I picked up the iron, the beads went flying everywhere.
After the beads are fused, thread a needle using sparkly thread. Poke a hole through the top, then tie off.
He is ready to go up on the tree!
Thanks for stopping by!
No comments:
Post a Comment